NEW! GERBER PROFILE CUTTER

In may 2002 STANCFORMA LTD purchased a profile cutter (new in Europe, unique in Hungary) definitely planned for making stampings.

The last 2 decades there were only 2 technologies for working wodden panels: -with saw or with laser -the test of International Association of Developing Dies (IADD) advices the profile cutter method, setting up from the problem of being little connection between the wood and the paralell by using lasers (Figure A)

The GERBER PROFILE CUTTER eleminates this problem by cutting a special Y causing the top and the bottom of the paralell is held by wood in 3-3 mm long. (Figure B)

Check out the animation

Further advantages:

• CNC controlled, high accuracy cutting
• multiple choice being capable of doing the works shown below by automatic change of cutter heads
  
  
  • pulling drawings
  • sample boxes (card board or corrugated board)
  • upper lower pressers
  • cutting pertinax